Datalogic PowerScan PD9530

Enter/Exit Programming Mode
252 PowerScan™ PD9530/PBT9500/PM9500
Arrow Down String (4-key models only)
Associate a pre-defined string to the Arrow Down key
$CDADS
Set string for Arrow Down Key
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left. Def
ine the label string by further scanning 32 dig-
its from the Alphanumeric characters in
Appendix
D, Keypad
.
The digits must be the hexadecimal ASCII representa-
tion of the desired characters; if less than the expected
string of 16 characters ar
e selected, scan the ENTER/
EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start again
at the beginning.
~
CANCEL