Datalogic PowerScan PD9530 User Manual

Enter/Exit Programming Mode
258 PowerScan™ PD9530/PBT9500/PM9500
Set String ID
Sets the identifier of the predefined strings.
$CPWEB
Set String ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 6 digits from the Alphanumeric charac-
ter
s in
Appendix D, Keypad .
The ID characters must be represented by their hexa-
decimal ASCII code; if the first 2 digits are 0, this feature
is disabled. End by scanning the E
N
TER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the ent
ry
string. You can then start again at the
beginning.
~
CANCEL
Set String Header
Sets the header of the predefined strings.
$CPWED
Set String Header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric c
harac-
ters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representation
of the desired characters. If less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER
/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the ent
ry
string. You can then start again at the
beginning.
~
CANCEL

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g