Datalogic PowerScan PD9530 User Manual

Product Reference Guide 325
Appendix C
Standard Defaults
The most common configuration settings are listed in the “Default” col-
umn of the table below. Page references are also provided for feature
descriptions and programming bar codes for each parameter.
A column
has also been provided for recording of your preferred default settings
for these same configurable features.
Table 56. Standard Defaults
Parameter Default Your Setting
Page
Nu
mber
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 23
USB Suspend Mode
Disable 23
RS-232 ONLY
Baud Rate
115200 26
Data Bits
8 Data Bits 27
Stop Bits
1 Stop Bit 27
Parity
None 28
Handshaking Control
RTS 29
RS-232/USB-Com
Intercharacter Delay
No Delay 31
Beep On ASCII BEL
Disable 31
Beep On Not on File
Enable 32
ACK NAK Options
Disable 32
ACK Character
‘ACK’ 33
NAK Character
‘NAK’ 33
ACK NAK Timeout Value
200 ms 34
ACK NAK Retry Count
3 Retries 34
ACK NAK Error Handling
Ignore Errors Detected 35

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g