Datalogic PowerScan PD9530 User Manual

Enter/Exit Programming Mode
236 PowerScan™ PD9530/PBT9500/PM9500
PM9500-ONLY FEATURES
The features in this section are valid only for the PowerScan PM9500 Star
model:
• STAR Radio Protocol Timeout on page 236
• STAR Radio Transmit Mode on page 237
STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the
handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-
ber of readers in the same area). The selectable range for this feature is
from 02 t
o 25 seconds. See page 305 in “References” for detailed informa-
tion and examples for setting this feature.
Set Radio Protocol Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by two digits from the
Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by scanning the
ENTER/EXIT bar code ag
ain.
Make a mistake? Scan the CANCEL barcode to abort
and no
t
save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
02 = 2 Seconds Radio Protocol Timeout

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g