Datalogic PowerScan PD9530

Enter/Exit Programming Mode
Product Reference Guide 249
Display Contrast
Adjust the contrast of the display.
$CDICT
Set Display Contrast
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by two digits (00-32 by 01) from the
Alp
hanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the
entry
string. You can then start again
at the beginning.
~
CANCEL
Font Size
Select the font size.
DEFAULT
$CDIFS00\r
Font Size = Small
$CDIFS01\r
Font Size = Medium
$CDIFS02\r
Font Size = Large