Datalogic PowerScan PD9530

Enter/Exit Programming Mode
270 PowerScan™ PD9530/PBT9500/PM9500
Set Key Sequence ID
Sets the identifier for keyboard composed strings.
$CPWEC
Set keys sequence ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed
by 6 digits from
Appendix D, Keypad .
The ID characters must be represented by their hexadeci-
mal ASCII code; if the first 2 digits are 0, this feature is dis-
abled. End by scanning the ENTER/EXIT bar co
de again.
Set Key Sequence Header
Sets the header for keyboard composed strings.
$CPWE1
Set key sequence header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric c
har-
acters in
Appendix D, Keypad . The digits must be
the hexadecimal ASCII representation of the desired
chara
cters.
If less than the expected string of 16 characters are
selected, scan the E
NTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is di
sabled. End by
sc
anning the ENTER/EXIT bar code again.
Set Key Sequence Terminator
Sets the terminator for keyboard composed strings.
$CPWE2
Set key sequence terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric c
har-
acters in
Appendix D, Keypad . The digits must be
the hexadecimal ASCII representation of the desired
chara
cters.
If less than the expected string of 16 characters are
se
lected, scan the E
NTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is disabled. End by
sc
anning the ENTER/EXIT bar code again.