Datalogic PowerScan PD9530

Enter/Exit Programming Mode
Product Reference Guide 257
Define Strings
Configure string 1-5.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code at the top of
the page, then the bar code for the String you want to set. Define the label string by scanning 32
digits from the Alphanumeric characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representation of the desired
characters; if less than
the expected string of 16 characters are selected, scan the ENTER/EXIT bar code to terminate
the string.
End by scanning the ENTER/EXIT bar code again.
$CPWEP
Set String 1
$CPWEO
Set String 2
$CPWEN
Set String 3
$CPWEM
Set String 4
$CPWEL
Set String 5
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL