Datalogic PowerScan PD9530 User Manual

Standard Defaults
338 PowerScan™ PD9530/PBT9500/PM9500
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan
either the Restore USA Factory Configuration bar code or the Restore EU
Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings, including the interface type.
CAUTION
Scanning either of the “Restore Factory Configuration” commands
below will result in the loss of any custom configuration settings
for your device. Go to
"Restore Custom Defaults" on page 18 if
you want to restore your custom configur
ation settings.
The USA label restores Label IDs to those historically used in the USA.
The EU label restores Label IDs to those historically used in Europe. The
Label ID sets for USA and EU are shown in Label ID: Pre-loaded Sets, starting
on page 288 of this manual.
$P,AE,P(CR)
Restore USA Factory Configuration
$P,Ae,P(CR)
Restore EU Factory Configuration

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g