vPad-A1 OPERATORS MANUAL
• The order of AutoSettings in a Group will only affect the sequence of appearance for each
corresponding Test Result interface. AutoSettings in a Group are always applied in close
succession before
prompting for their Results.
• A
Group can only be deleted if it contains no AutoSettings.
• Default Group names can be changed by pressing and holding the Group name bar until an
input box appears.
Changes made in the Editor will not persist if users do not save the file. Saving an AutoSequence
without changing the pre-populated file name will overwrite the selected template.
When
AutoSequence editing is complete, return to the A1 Main screen by touching the Back
button by swiping left on the Editor screen.
Note that vPad-A1 can be further automated when used in conjunction with vPad-Check and the
VPL procedure system. Refer to the vPad-Check manual (MN-084 vPad-Check Operators Manual,
Chapter 4.2 for further details), in particular regarding the use of the run statement.
Automation and Test Records/Chapter 5 # Page 87
To Next Page
Loading...
Need help?
General