vPad-A1 OPERATORS MANUAL
The Action Controls section of the Editor presents tools for
working with the active AutoSequence Group or AutoSetting entry.
Touching and holding a
Group name bar will allow users to edit the
name of the Group. The Action Controls can be enlarged by
pressing one of the buttons at the bottom of the screen.
Icon Action
Move the active AutoSetting entry up one in the list.
Move the active AutoSetting entry down one in the
list.
Create a new Group in the AutoSequence.
Move the active Group up one in the list.
Move the active Group down one in the list.
Remove the active (empty) Group or AutoSetting
entry.
Permanently delete the selected AutoSequence file.
Save or rename the selected AutoSequence file.
When working with the Groups viewer and Action Controls, note the following:
• If users enter the
Editor without an active AutoSequence selected, the Groups list will be
empty. A user must then add at least a single Group before adding AutoSettings.
• A Group can contain only one AutoSetting from each parameters category. To replace an
AutoSetting with another of the same type, first remove the original AutoSetting before
adding the new selection.
• The order of
Groups in an AutoSequence will affect the sequence of execution.
Figure 134
- Action Controls
Figure 135
- Large Action
Controls Toolbar
Automation and Test Records/Chapter 5 # Page 86
To Next Page
Loading...
Need help?
General