EasyManuals Logo

DATREND Systems vPad-A1 User Manual

DATREND Systems vPad-A1
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
vPad-A1 OPERATORS MANUAL
vPad-BP
module:
• NIBP – simulator adapter between blood
pressure cuff and monitor hose
vPad-A1 is normally used while running on its internal batteries. When the vPad-A1 App indicates that
batteries are low, users should recharge the batteries by connecting the DC power supply and AC power
cord between the Base unit and a mains outlet. The Tablet can be recharged by connecting it to the USB
Port on the the Base using the microUSB cable provided with vPad-A1.
If the vPad-A1 will not be in use for an extended period of time, exit the A1 App and switch the Base unit
and the Tablet OFF. To power OFF the Tablet, press and hold the Power / Screen Lock button until a
confirmation message appears on the screen, then select the appropriate response to complete the Power
Off sequence. For long-term storage or transport, simply proceed through the setup procedure in reverse
from
Figure 15
to
Figure 5
above.
Figure 13
Figure 14 Figure 15
Setup/Chapter 3 # Page 26

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DATREND Systems vPad-A1 and is the answer not in the manual?

DATREND Systems vPad-A1 Specifications

General IconGeneral
BrandDATREND Systems
ModelvPad-A1
CategorySwitch
LanguageEnglish