Monitor
Suspend
Timer
(1)
Disabled
1 min.
5 min.
10 min.
15 min.
20 min.
25 min.
30 min.
Allows to disable the monitor suspend feature, or, after a set period of
keyboard, mouse, or keyboard controller inactivity, allows to place the
monitor in a suspend state (minimum power saving state).
When placed in the suspend state, the monitor instantaneously
resumes to full-power capabilities.
Hard Disk
Suspend
Timer
(1)
Disabled
Enabled
Allows to disable or enable the hard disk suspend feature, or, after a
set period of disk drive inactivity, allows the hard disk drive to spin
down it's motor to save power.
Note: This option allows to place the hard disk drive in suspend
power saving mode. When enabled, and after approximately 20
minutes of hard disk drive inactivity, the hard disk drives spindle and
actuator motor will spin down with the drive head parked in the
landing zone until disk activity resumes.
System
Suspend
Timer
(1)
Disabled
30 min.
1 hour
1.5 hours
2 hours
3 hours
6 hours
12 hours
Allows to disable the system suspend feature, or, after a set period of
computer inactivity, allows to place the computer in a suspend state
(maximum power saving state).
Note: This option allows to place the computer in suspend power
saving mode. While in suspend, the computer enters the maximum
power saving mode. This means the monitor is off, the hard disk
drive enters its suspend state, the CPU clock stops, and the cooling fan
stops. Note that computer interrupts can break the system suspend
state with the exception of IRQ 0 and 8.
(1)
(LPx+ only).
(2)
(LPx 560/566 only).
To Next Page
Loading...
Need help?
General
