Revision v2.10
Update of version number to v2.10
Various typographical changes and formatting corrections
Correct the fixed value in the first three hex digits to be 0x100 and not 0x101 as previously
suggested.
Updated definitions of FP_AMPL1 and FP_AMPL3
Update for setting MSGP0 bit 7, was reserved, now indicates how it is used to allow the system
clock appear on GPIO0
Added text about optimizing SFD timeout value.
Updated description of TX_PSTM for inter frame spacing
Revision v2.11
Update of version number to v2.11
Various typographical changes and formatting corrections
Added Sect 5.3.6 ACK corruption text added
Amend TX and RX_Buffer descriptions
Updated description on TXSTRT bit
R(report) added to RXPF in Register REG:10:00 – RX_FINFO – RX Frame Information to match the
resume table.
Addition of prohibition of writing to receive buffer
Modification to Table 21 and addition of new Table 22. Renumbering of all subsequent tables.
Change sub register 0x28:0C– RF_TXCTRL to 24 (3bytes)
Table 37 . Change 32 to 24 bit
Added new section for details on “Carrier Recovery Integrator Register”
Addition of previously undocumented transmitter calibration pulse generator registers
Correction to desctiption of register 0x2F:06 section 7.2.48.3
Write correct value Sub-Register 0x2B:0B – FS_PLLTUNE
Removal of restriction on writing only the default values to 0x2E:1806, section 7.2.47.6
Table 55, Change power at receiver input for ch 4 and ch7 to -104 (dBm/Mhz)
Addition of correct post code
To Next Page