decaWave DW1000 - Page 241

DW1000 User Manual
© Decawave Ltd 2017
Version 2.12
Page 241 of 242
Revision v2.12
Page
Change Description
All
Update of version number to v2.12
61
To read OTP OTP_RDAT change 2A.04 to 2D:0A (see also 7.2.46.5) Row 5 removed.
106
New note on requirement for isolation of VDDPA1 and VDDPA2 if using Tx gain setting 000
128
Note added to point out that GPIO clocks have to be on to use GPIO lines.
132
Sec 7.2.39.3 GDM6 is declared as bit 15, but it is bit 14
133
Sec 7.2.39.4 GOP2 should refer to GPIO2 and GOP3 should refer to GPIO3
140
Changed the sentence to "The bits of the GPIO_RAW register identified above are
individually described below:"
157
PG_TMEAS changed to reg:2A:08 bit5:2, it was given 4:2
238
Addition of this table