• Generator Voltage (ph-N)
• Generator Voltage (ph-ph)
• Generator Frequency
• Generator Current (A)
• Generator Load ph-N (kW)
• Generator Total Load (kW)
• Generator Load ph-N (kVA)
• Generator Total Load (kVA)
• Generator Power Factor Average
• Generator Load ph-N (kVAr)
• Generator Total Load (kVAr)
• Generator Accumulated Load (kWh, kVAh, kVArh)
• Generator Phase Sequence
• Active Configuration
4.4.4 MAINS (DSE6120 MKII ONLY)
NOTE*: Mains current and powering monitoring is only available when the CTs are
configured for, and placed in the load. For further details of module configuration, refer to
DSE Publication: 057-224 DSE6110 MKII & DSE6120 MKII Configuration Software Manual.
These Pages contain electrical values of the mains, measured or derived from the module’s voltage
inputs.
Mains
50.0
• Mains Voltage (ph-N)
• Mains Voltage (ph-ph)
• Mains Frequency
• Mains Current (A)*
• Mains Phase Sequence
• Mains Load ph-N (kW)*
• Mains Total Load (kW)*
• Mains Load ph-N (kVA)*
• Mains Total Load (kVA)*
• Mains Single Phase Power Factor*
• Mains Average Power Factor*
• Mains Load ph-N (kVAr)*
• Mains Total Load (kVAr)*
• Mains Accumulated Load (kWh, kVAh, kVArh)*
To Next Page
Loading...
