Deep Sea Electronics Plc DSE6120 MKII

Description Of Controls
057-236 ISSUE: 1 Page 56 of 94
4.4.10 ABOUT
4.4.10.1 MODULE INFORMATION
Contains important information about the module and the firmware versions. This information may be
asked for when contacting DSE Technical Support Department for advice.
About
Variant
Application
USB ID
6120H
V1.1.5
BC614E
Press the Scroll Down
button to access more information about the module.
About
Bootloader
Analogue
V1.4.0
V2.0.1
About
Engine Type
Version
Volvo EMS2b
V1.21
4.4.10.2 SUPPORT STRINGS
NOTE: For further details of module configuration, refer to DSE Publication: 057-224
DSE6110 MKII & DSE6120 MKII Configuration Software Manual.
The support string pages are intended to contain important information about the generator supplier
company such as contact information. The contents of these screens vary depending upon
configuration by the engine manufacturer or supplier.
Under default factory settings the support strings are not viewable. They are configurable by the
system designer using the DSE Configuration Suite software.
The display below example screen is achieved using the settings shown in the below screen shot of
the DSE Configuration Suite Software:
Support
Deep Sea Electronics
+44 (0)1723 890099
support@deepseaplc.com
• Variant (61xx MKII)
• Application Version – The version of the module’s
main firmware file (Updatable using the Firmware
Update Wizard in the DSE Configuration Suite
Software).
• USB ID – Unique identifier for PC USB connection
• Bootloader - Firmware Update bootloader software
version
• Analogue – Analogue measurements software
version
• Engine Type – The name of the engine file
selected in the configuration
• Engine – Engine type file version.