7.2 ‘RUNNING’ CONFIGURATION EDITOR
7.2.1 ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
• The ‘running’ editor can be entered whilst the engine is running. All protections remain active if
the engine is running while the running editor is entered
• Press and hold together the Menu Navigation
buttons to access the Running Editor
7.2.2 ENTERING PIN
NOTE: The PIN is not set by DSE when the module leaves the factory. If the module has a
PIN code set, this has been affected by your engine supplier who should be contacted if you
require the code. If the code has been ‘lost’ or ‘forgotten’, the module must be returned to
the DSE factory to have the module’s code removed. A charge is made for this procedure.
NB - This procedure cannot be performed away from the DSE factory.
NOTE: The PIN is automatically reset when the editor is exited (manually or
automatically) to ensure security.
• Even if a module security PIN has been set, the PIN is not requested whilst entering the ‘running’
editor.
7.2.3 EDITING A PARAMETER
• Press either of the Menu Navigation
buttons to cycle to the parameter within the section
chosen to be edited.
• Press the Tick
button to edit the parameter. The parameter begins to flash to indicate that the
parameter is being edited.
• Press the Previous
-
& Next
+
buttons to adjust the parameter to the required value.
• Press the Tick
button to stop editing the paramter. The parameter ceases flashing to indicate
that it the parameter is no longer being edited
To Next Page
Loading...
