GC-1F Installation Instructions and Reference Handbook
DEIF A/S Page 69 of 123
M-Logic
M-Logic functionality is included in the unit and is not an option-dependent function.
M-Logic is used to execute different commands at predefined conditions. M-Logic is not a PLC
but substitutes one, if only very simple commands are needed.
M-Logic is a simple tool based on logic events. One or more input conditions are defined, and at
the activation of those inputs the defined output will occur. A great variety of inputs can be
selected, such as digital inputs, alarm conditions and running conditions. A variety of the outputs
can also be selected, such as relay outputs, change of genset modes, alarm LEDs and change
of running modes.
The main purpose of M-Logic is to give the operator/designer more flexible possibilities of
operating the generator control system.
The M-Logic is part of the PC utility software, and as such it can only be
configured in the PC utility software and not via the display.
To Next Page
Loading...
