Deif GC-1F - Buzzer

GC-1F Installation Instructions and Reference Handbook
DEIF A/S Page 70 of 123
Buzzer
The GC-1F has a built-in buzzer. The buzzer is configured in M-Logic. This means that if the
buzzer is going to be used as a horn annunciator, the input must be set to “Horn” and the output
must be set to “Buzzer”. The buzzer will act concurrently to the horn output timer. If the delay
timer in M-Logic is used, the buzzer will be active after this time delay. See example below.
If an AOP-2 is connected, the buzzer in the AOP-2 must be configured under the
AOP-2 setup. But the configuration of the AOP-2 buzzer is similar to the above.