Delem DA-56 - Page 12

V0505, 1.6
3
Creation of a new CNC-program by data entry (numeri-
cal).
4
To edit an existing CNC-program by data entry (numeri-
cal).
5
To select a program out of the product library.
6
Write programs to or read programs from a back-up
medium.
7
To program the dimensions of the upper tools.
8
To program the dimensions of the under tools.
9
To program the dimensions of the upper side of your
machine.
10
To program the dimensions of your machine table.
11
To program specific programming data.
12
Write or read tooling data and machine shapes to or from
a back-up medium.