V0505, 1.2
1.2. Operation modes
The control has the 4 following modes:
Each mode can be selected by pressing the relevant push button. A LED in the push button
indicates whether or not this mode is active.
Manual mode In this mode it is possible to program all parameters of
just one bending. After pushing the start button all param-
eters are active and the backgauge will go into position. It
is also possible to move the axes manually.
Programming
mode
In this mode bend programs can be made or edited and
also be written to or read from disk.
Automatic
mode
The selected program can be executed automatically.
Step by step
mode
The selected program can be executed bend by bend.
To Next Page
Loading...
