Delem DA-56 User Manual

Delem
V0505, 7.7
dling.
7.5. Computation settings
7.e
Active bend allowance table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BE =
0 = Internal / 1 = bendallw.tab
Bend-allowance: correction of the X-axis due to plate shortening after bending. With this
parameter the method for bend-allowance calculation is chosen. ‘Internal’ means the
standard formula of the control is used to calculate the bend-allowance. ‘Bendallw.tab’
means a bend-allowance table with correction values can be used. The choice ‘Ben-
dallw.tab’ is only available if a bend-allowance table is present on the control.
If a table has been chosen, the name of that table (if it has a name) is shown on the
screen.
Press the key to select the required setting.
Data preparation bend allowance . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BA =
0 = correction off / 1 = correction on
With this parameter you can choose whether or not you wish to have programmed values
corrected for bend-allowance. This on/off setting only refers to corrections during prod-
uct programming in the menu ‘data preparation’. If a numeric program has been entered
with corrections on, the axis corrections are calculated and stored in the program. These
corrections can be viewed and edited in production mode (see ‘Automatic mode’).
Press the key to select the required setting.
This choice has no effect on the postprocess function in the drawing mode. When the control

Delem DA-56 Specifications

General

Brand	Delem
Model	DA-56
Category	Controller
Language	English