Delem DA-56 - Program Constants; Introduction; General

Delem
V0505, 7.1
7. Program Constants
7.1. Introduction
Choose ‘Program constants’ in the main menu to program the programming constants. The
program constants are divided across several pages. They are discussed in the following sec-
tions.
7.2. General
7.a
Inch-select 1/0 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .IS
1 = dimensions in inches
0 = dimensions in millimeters
Press the key to select the required setting.
Ton/kN select 1/0 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TS
1 = Ton
0 = kN
It is possible to select the units for all Force data to be expressed in Tons or kN.
Press the key to select the required setting.