V0505, 6.6
To load or save only a few tools, go to the specific menus of those tools and save or load each
tool individually. This has been explained in detail in the chapter about tools.
A restore operation runs similar to a back-up operation, when it is started a warning is given
that the existing tools on the control will be replaced by the tools that are imported.
Tools are linked to the control by their machine number. When a restore operation is started,
the control will only import those tools, which have the same machine number as the control.
If for any reason the machine number is changed, a new tool back-up operation should be exe-
cuted to save the control tools with their new machine number. If this has not been done, the
control will detect no tools at the next restore action.
6.f
restore tools restore all tools from disk.
backup direc-
tory
change, make or remove backup directory
Function keys:
To Next Page
Loading...
