Delem
V0505, 2.21
2.u
When update (S4) is chosen, the existing CNC program is changed with regard to modified
values (angle, length), but other values of bend parameters stay the same. The expression ‘re-
use corrections’ refers to the corrections that may have been entered in one of the production
modes. These production modes are explained in chapter 10.
When new (S5) is chosen, a new CNC program is calculated. Corrections in the existing CNC
program are lost.
In order to keep the existing program, check that the indication ‘Variants On’ remains in the
title bar. When you start an action or command that would seriously change the program, a
warning is issued by the control:
To Next Page
Loading...
