V0505, 3.16
When a bend has been marked with the function key 'mark bend' several other function keys
become available:
Move bend
In the spreadsheet overview of the bendsequence, it is possible to change the order of bends
simply by moving a bend to another place. Use the arrow keys to move the cursor to the bend
Function keys:
prev. bend To go to a previous bend when available.
next bend To go to a next bend when available.
insert bend To insert a new bend between one of the bends, select
with the cursor keys first the bend after which a bend
must be inserted. Then push S1 for inserting, results in a
new bend which is a copy of the previous one.
delete bend To delete a bend of the program first select this bend with
the cursor (highlighted bar).
mark bend Mark the current bend, in order to prepare it for another
action, like move or swap. See description below.
END Back to bend parameters.
Function keys:
move bend With this command the bend sequence can be edited in
this screen.
swap bends Let two bends exchange places.
abort mark Remove the mark from the currently marked bend.
To Next Page
Loading...
