NOTE: Press the retention frame while tightening the screws to avoid tilting of the processor cover out of the
processor socket.
Figure 104. Securing the retention frame
Next steps
1. Install the heat sink or Install the liquid cooling module.
2. Install the air shroud.
3. Follow the procedure listed in After working inside your system.
Installing the heat sink
Prerequisites
Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. If installed, remove the processor dust cover.
Steps
1. If you are using an existing heat sink, remove the thermal grease on the heat sink by using a clean lint-free cloth.
NOTE:
For a new heat sink, the thermal paste is pre-applied to the heat sink. Remove the protective cover, and install
the heat sink.
2. Apply thermal grease in a thin spiral on the top of the processor.
Installing and removing system components
129
To Next Page
Loading...
