Dell PowerEdge R6615 9JNDF - VGA module; Removing the VGA module

Figure 134. Installing the serial COM port
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, Remove the front bezel.
4. Remove the backplane cover.
5. If installed, Remove the air shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Disconnect the VGA cable from the connector on the system board and open the cable latch.
2. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the
system.
164
Installing and removing system components