Dell PowerEdge R6615 9JNDF - Installing the rear HDD drive module

6. If installed, remove the expansion card riser.
Steps
1. Using a Phillips #1 screwdriver, loosen the captive screws on the rear drive module.
2. Slide the rear drive module and lift it away from the system.
Figure 49. Removing the rear HDD
Next steps
1. Replace the rear drive module.
Installing the rear HDD drive module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
Steps
1. Align the rear drive module with the guide on the system board.
2. Lower the rear drive module and slide till it clicks.
3. Using a Phillips #1 screwdriver, tighten the captive screws on the rear drive module.
82
Installing and removing system components