Dell PowerEdge R6615 9JNDF - Installing the BOSS-N1 card carrier blank

Figure 141. Removing the BOSS-N1 card carrier blank
Next steps
1. Replace the BOSS-N1 card carrier blank or install BOSS-N1 card carrier.
Installing the BOSS-N1 card carrier blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
1. Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
2. Using a Phillips #1 screwdriver, replace the screws that secures the BOSS-N1 card carrier blank to the chassis.
3. Connect the power cable and the signal cable to the system board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
170 Installing and removing system components