Dell PowerEdge R6615 9JNDF - Installing the BOSS-N1 module

Next steps
1. Replace the BOSS-N1 module or Install the BOSS-N1 module blank.
Installing the BOSS-N1 module
The procedure to install is the BOSS-N1 module with 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, remove the BOSS module blank.
Steps
1. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Figure 147. Connecting the BOSS-N1 power and signal cables to the BOSS-N1 module
2. Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until firmly seated.
3. Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screws.
4. Connect the BOSS-N1 power and signal cable to the connectors on the system board.
174
Installing and removing system components