Dell PowerEdge R6615 9JNDF - NIC port specifications; Serial connector specifications; VGA ports specifications

Figure 26. Internal USB Port
NIC port specifications
The PowerEdge R6615 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on
the LAN on Motherboard (LOM) and integrated on the Open Compute Project (OCP) cards.
Table 22. NIC port specification for the system
Feature Specifications
LOM card (optional) 1 GB x 2
OCP card (OCP 3.0) (optional) 1 GbE x 4, 10 GbE x 2, 10 GbE x 4, 25 GbE x 2, 25 GbE x 4
NOTE: The system allows either LOM card or an OCP card or both to be installed in the system.
NOTE: On the system board, the supported OCP PCIe width is x8; when x16 PCIe width is installed, it is downgraded to x8.
Serial connector specifications
The PowerEdge R6615 system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant .
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R6615 system supports two DB-15 VGA port one each on the front and back panel.
Technical specifications
31