Figure 136. Installing the VGA module
Next steps
1. Route the VGA cable, close the cable latch, and connect the VGA cable to the connector on the system board.
2. Route and connect the right control panel cable.
3. If removed, Install the air shroud.
4. Install the backplane cover.
5. If installed, Install the front bezel.
6. Follow the procedure listed in the After working inside your system.
M.2 SSD module
Removing the M.2 NVMe SSD module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the BOSS-N1 module.
Steps
1. Using the Phillips #1 screwdriver, remove the M3 x 0.5 x 4.5 mm screw securing the M.2 NVMe SSD module to the BOSS-N1
card.
2. Pull the M.2 NVMe SSD module to disconnect from the BOSS-N1 card connector.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
166 Installing and removing system components
To Next Page
Loading...
