Dell PowerEdge R6615 9JNDF - Optional serial COM port; Removing the serial COM port

Figure 132. Installing an expansion card into the expansion card riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Install the expansion card risers.
3. Install the air shroud.
4. Follow the procedure listed in After working inside your system.
5. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
The procedure to remove serial COM port from Riser 3 or 4 is same.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
Steps
1. Disconnect the serial COM port cable from the connector on the rear I/O board.
2. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
162 Installing and removing system components