Dell PowerEdge R6615 9JNDF - Removing expansion card from the expansion card riser

Figure 127. Installing the expansion card riser 3
Figure 128. Installing the expansion card riser 4
Next steps
1. If required, reconnect the cables to the expansion card or system board.
2. Install the air shroud .
3. Follow the procedure listed in After working inside your system.
4. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
158
Installing and removing system components