Figure 87. Installing the rear mounting front PERC module
Next steps
1. Install the drive backplane.
2. If removed, install the air shroud.
3. Install the drive backplane cover.
4. Follow the procedure listed in After working inside your system.
Removing H965 PERC and battery module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the drive backplane cover.
4. If installed, remove the air shroud.
5. Disconnect all the cables, observe the cable routing.
Steps
1. Disconnect the power cable from the PERC power connector.
2. Remove the power cable from the clip and lift the PERC battery out of the battery tray.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 115
To Next Page
Loading...
