EasyManua.ls Logo

Dell PowerEdge R6615 9JNDF - Rear view of the system

Dell PowerEdge R6615 9JNDF
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 5. Features available on the front of 16 x E3.S drive system
Item Ports, panels, and
slots
Icon Description
1 Left control panel N/A Contains the system health, system ID, and the status LED indicator.
2 E3.S Drive N/A Enables you to install drives that are supported on your system.
3 Right control panel N/A Contains the power button with integrated power LED, 1 x VGA port,
1 x 2.0 USB port, iDRAC Direct (Micro-AB USB) port, and the iDRAC
Direct status LED.
4 VGA N/A Enables you to connect a display device to the system.
5 Information tag N/A The Express Service Tag is a slide-out label panel that contains
system information such as Service Tag, NIC, MAC address, and so
on. If you have opted for the secure default access to iDRAC, the
Information tag will also contain the iDRAC secure default password.
NOTE: For more information about ports, panels, and slots, see the Technical specifications section.
Rear view of the system
Figure 6. Rear view of system
Table 6. Rear view of the system
Item Ports, panels, or slots Icon Description
1 BOSS N/A Insert BOSS blank when BOSS module is not used.
2 Power supply unit (PSU1) PSU1 is the primary PSU of the system.
3 PCIe expansion card riser 1
(slot 1)
N/A The expansion card riser enables you to connect PCI Express
expansion cards.For more information, see the Expansion card
installation guidelines section.
4 PCIe expansion card riser 4
(slot 2)
N/A The expansion card riser enables you to connect PCI Express
expansion cards.For more information, see the Expansion card
installation guidelines section.
5 Power supply unit (PSU2) PSU2 is the secondary PSU of the system.
6 VGA port Enables you to connect a display device to the system.
7 USB 2.0 port The USB port is 4-pin, 2.0-compliant. This port enables you to
connect USB devices to the system.
8 USB 3.0 port The USB ports are 9-pin, 3.0-compliant. These ports enable you to
connect USB devices to the system.
9 Dedicated iDRAC9 Ethernet
port
Enables you to remotely access iDRAC. For more information,
see the Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
10 OCP NIC card The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
12 System overview

Table of Contents

Related product manuals