Table 6. Rear view of the system(continued)
Item Ports, panels, or slots Icon Description
11 NIC ports N/A The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
Figure 7. Rear view of the system with 2 x 2.5-inch rear drive module
Table 7. Rear view of the system with 2 x 2.5-inch rear drive module
Item Ports, panels, or slots Icon Description
1 BOSS N/A Insert BOSS blank when BOSS module is not used.
2 Power supply unit (PSU1) PSU1 is the primary PSU of the system.
3 Drives N/A Enables you to install drives that are supported on your system.
4 PCIe expansion card riser 3
(slot 3)
N/A The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the Expansion card
installation guidelines section.
5 Power supply unit (PSU2) PSU2 is the secondary PSU of the system.
6 VGA port Enables you to connect a display device to the system.
7 USB 2.0 port The USB port is 4-pin, 2.0-compliant. This port enables you to
connect USB devices to the system.
8 USB 3.0 port The USB ports are 9-pin, 3.0-compliant. These ports enable you to
connect USB devices to the system.
9 Dedicated iDRAC9 Ethernet
port
Enables you to remotely access iDRAC. For more information,
see the Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
10 OCP NIC card The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
11 NIC ports N/A The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
Figure 8. Rear view of the system with Direct Liquid Cooling module
Table 8. Rear view of the system with Direct Liquid Cooling module
Item Ports, panels, or slots Icon Description
1 BOSS N/A Insert BOSS blank when BOSS module is not used.
System overview 13
To Next Page
Loading...
