● Needle-nose pliers
You need the following tools to assemble the cables for a DC power supply unit:
● AMP 90871-1 hand-crimping tool or equivalent
● Tyco Electronics 58433-3 or equivalent
● Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
NOTE: For information about DC PSU cabling instructions, go to https://www.dell.com/poweredgemanuals > Rack
Servers > PowerEdge R6615 > Select This Product > Documentation > Manuals and Documents > Cabling
instructions for – 48 – 60 V DC power supply.
Optional front bezel
NOTE: LCD panel is optional on the front bezel. If the front bezel has an LCD panel, see LCD panel section.
Removing the front bezel
Prerequisites
1. Follow the safety guidelines listed in the Safety Instructions.
2. Keep the bezel key handy.
NOTE: The bezel key is part of the bezel package.
Steps
1.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Unlock the bezel .
2. Press the release button, and remove the left end of the bezel.
3. Slide the tabs on the right end of the bezel out of the slots on the chassis and remove the bezel.
64
Installing and removing system components
To Next Page
Loading...
