Figure 50. Installing rear drive module
Next steps
1. Connect all the cables to the rear drive module.
2. Install the rear drives.
3. Install the air shroud.
4. Follow the procedure listed in After working inside your system
Removing the rear E3.S drive module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove the rear drives.
5. Disconnect all the cables from the rear drive module.
6. If installed, remove the expansion card riser.
Steps
1. Press the blue release tab or blue button on the rear drive module to disengage.
2. Holding the edges, lift the rear drive module out of the system board.
Installing and removing system components
83
To Next Page
Loading...
