Dell PowerEdge R6615 9JNDF - Removing the BOSS-N1 card carrier blank

Figure 140. Installing the BOSS-N1 module blank
Removing the BOSS-N1 card carrier blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
1. Disconnect the power cable and the signal cable from the system board.
2. Using a Phillips #1 screwdriver, remove the screws that secures the BOSS-N1 card carrier blank to the chassis.
3. Remove the BOSS-N1 card carrier blank out from the BOSS-N1 module.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 169