192 Solving Problems
www.dell.com | support.dell.com
ALERT! PREVIOUS REBOOT WAS DUE TO VOLTAGE REGULATOR
FAILURE — The VRM failed the last time you used the computer. See
"Contacting Dell" for assistance.
ALERT! PREVIOUS SHUTDOWN DUE TO THERMAL EVENT — The
microprocessor overheated the last time you used the computer. Ensure that
nothing is blocking the airflow vents and that all the fans are working correctly.
Also, ensure that the microprocessor heat sink is properly installed.
ALERT! PREVIOUS VOLTAGE FAILURE — Voltage used by the computer
either exceeded or fell below acceptable thresholds. See "Power Problems" and
"System Board Problems."
ALERT! PROCESSOR CACHE SIZE MISTMATCH. INSTALL LIKE
PROCESSORS OR ONE PROCESSOR. SYSTEM HALTED!—Tw o
processor with different cache sizes are installed. See "Microprocessor."
ALERT! PROCESSOR SPEED MISMATCH. INSTALL LIKE PROCESSORS
OR ONE PROCESSOR. SYSTEM HALTED!—Two processor with different
speeds are installed. See "Microprocessor."
ALERT! PROCESSOR TYPE MISMATCH. INSTALL LIKE PROCESSORS
OR ONE PROCESSOR. SYSTEM HALTED!—Two processor with different
types are installed. See "Microprocessor."
ALERT! SYSTEM BATTERY VOLTAGE IS LOW — The computer battery is
providing inadequate voltage. See .
ALERT! UNSUPPORTED HIGH POWER AGP PRO VIDEO ADAPTER
D
ETECTED. SYSTEM HALTED!—A high-power AGP Pro110 video adatper
is installed. Replace the AGP Pro110 video adapter with an AGP Pro50 adapter.
See Cards.
NOTE: This error message applies only to Dell Precision 450 computers.
ALERT! UNSUPPORTED PROCESSOR TYPE DETECTED. SYSTEM
H
ALTED!—Replace the microprocessor. See "Microprocessor."
To Next Page
Loading...
