Solving Problems 193
ALERT! UNCORRECTABLE MEMORY ERROR PREVIOUSLY
DETECTED... ADDRESS
xxxxxxxx
H — One or more memory modules may
be improperly seated or faulty or the system board may be faulty. See "Memory
Problems" and "System Board Problems."
ATTACHMENT FAILED TO RESPOND — The floppy or hard drive controller
cannot send data to the associated drive. See "Floppy drive problems" or "Hard
drive problems" for troubleshooting suggestions.
BAD COMMAND OR FILE NAME — Ensure that you have spelled the
command correctly, have put spaces in the proper place, and have used the
correct pathname.
BAD ERROR-CORRECTION CODE (ECC) ON DISK READ — The floppy or
hard drive controller detected an uncorrectable read error. See "Floppy drive
problems" or "Hard drive problems" for troubleshooting suggestions.
CONTROLLER HAS FAILED — The hard drive or the associated controller is
defective. See "Floppy drive problems" or "Hard drive problems" for
troubleshooting suggestions.
DATA ERROR — The floppy or hard drive cannot read the data.
• For the Microsoft
®
Windows
®
operating system, run the chkdsk utility to
check the file structure of the floppy or hard drive.
• For another operating system, run the appropriate corresponding utility.
See your operating system documentation for information on running these
utilities.
DECREASING AVAILABLE MEMORY — One or more memory modules
might be faulty or improperly seated.
• Reinstall the memory modules and, if necessary, replace them.
• See "Memory Problems" for additional troubleshooting suggestions.
DISKETTE DRIVE 0 SEEK FAILURE — A cable might be loose or the
computer configuration information may not match the hardware configuration.
See "Floppy drive problems" for troubleshooting suggestions.
To Next Page
Loading...
