48
Installing Optional Accessories
Auto SSID Setup
1
Press the
(Menu)
button.
2
Press the button until
Admin Settings
is highlighted, and then press the
(Set)
button.
3
Press the button until
Network
is highlighted, and then press the
(Set)
button.
4
Press the button until
Wi-Fi
is highlighted, and then press the (
Set
) button.
5
Press the button until
Wi-Fi Setup
is highlighted, and then press the
(Set)
button.
The printer automatically searches the access points on wireless network.
6
Press the button until the desired access point is highlighted, and then press the
(Set)
button.
If the desired access point does not appear, go to "Manual SSID Setup."
NOTE:
Some hidden SSID may not be displayed. If the SSID is not detected turn on SSID broadcast from the router.
7
Enter the WEP key or pass phrase.
When the encryption type of the selected access point is WEP in step 6:
• Enter the WEP key, and then press the
(Set)
button.
When the encryption type of the selected access point is WPA, WPA2 or Mixed in step 6:
• Enter the pass phrase, and then press the
(Set)
button.
8
The
Restart System
screen appears.
9
Turn off the printer, and turn it on again to apply the settings.
Wireless LAN connection setting is complete.
Manual SSID Setup
1
Press the
(Menu)
button.
2
Press the button until
Admin Settings
is highlighted, and then press the
(Set)
button.
3
Press the button until
Network
is highlighted, and then press the
(Set)
button.
4
Press the button until
Wi-Fi
is highlighted, and then press the (
Set
) button.
5
Press the button until
Wi-Fi Setup
is highlighted, and then press the
(Set)
button.
6
Press the button until
Manual Setup
is highlighted, and then press the
(Set)
button.
7
Enter the SSID, and then press the
(Set)
button.
8
Select the network mode from
Infrastructure
and
Ad-hoc
depending on your environment, and then press
the
(Set)
button.
If you select
Infrastructure
, proceed to step 9.
If you select
Ad-hoc
, proceed to step 10.
9
Select the encryption type from
No Security
,
Mixed mode PSK
,
WPA2-PSK-AES
, or
WEP
.
If you do not set security for your wireless network:
•Press the
button until
No Security
is highlighted, and then press the
(Set)
button.
To use Mixed mode PSK, or WPA2-PSK-AES encryption:
a
Press the button until
Mixed mode PSK
or
WPA2-PSK-AES
is highlighted, and then press the
(Set)
button.
b
Enter the passphrase, and then press the
(Set)
button.
To Next Page
Loading...
