Revision February, 2017 2-1
Chapter 2 Installation
2.1 Notes
Please pay special attention to the followings:
If the connection between the servo drive and the servo motor is over 20 meters, please
thicken the connecting wire, UVW as well as the encoder cable. Please refer to section 3.1.6
for further information.
2.2 Ambient Conditions of Storage
Before the installation, this product has to be kept in shipping carton. In order to retain the warranty
coverage and for the maintenance, please follow the instructions below when storage, if the
product is not in use temporally:
Store the product within an ambient temperature range of -20 ℃ to +65 ℃.
Store the product within a relative humidity range of 0% to 90% and a non-condensing
environment.
Avoid storing the product in the environment of corrosive gas and liquid.
2.3 Ambient Conditions of Installation
The ambient conditions of installing and operating the servo drive:
Location has no over-heat device, no water drop, vapor, dust and oily dust, no corrosive and
inflammable gas and liquid, no airborne dust and metal particles, no interference of
electromagnetic noise and has solid foundation and no vibration.
The ambient conditions of operating the servo motor:
The ambient temperature is between 0 ℃ and 40 ℃. And the ambient location shall has no over-
heat device, no water drop, vapor, dust and oily dust, no corrosive and inflammable gas and liquid,
no airborne dust and metal particles.
The best temperature of this servo drive is between 0 ℃ and 55 ℃. If the temperature is over 45 ℃,
please place the product in a well-ventilated environment so as to ensure its reliability performance.
If the product is installed in an electric box, make sure the size of the electric box and its ventilation
condition will not overheat and endanger the internal electronic device. Also, pay attention to the
vibration of the machine. Check if the vibration will influence the electronic device of the electric
box.
To Next Page
Loading...
