Delta ASD-A2-7543 Series - Page 596

Chapter 10 Troubleshooting ASDA-A2
Revision February, 2017 10-33
AL301
：CANopen fails to synchronize
NMT: Reset node or 0x6040.Fault
Reset
AL302
：The synchronized signal of CANopen is
sent too fast
NMT: Reset node or 0x6040.Fault
Reset
AL303
：The synchronized signal of CANopen is
sent too slow
NMT: Reset node or 0x6040.Fault
Reset
AL304
：CANopen IP command is failed
NMT: Reset node or 0x6040.Fault
Reset
AL305
：SYNC Period is in error
NMT: Reset node or 0x6040.Fault
Reset
AL380
：Position Deviation Alarm
DI.Alm Reset or P0-01 = 0
AL400
：Index coordinates error
Turn DI.ARST on to clear the alarm.
AL401
：NMT Reset command is received when
Servo On
Turn DI.ARST on to clear the alarm.
AL404
：Value of PR special filter setting is too big
Turn DI.ARST on to clear the alarm.
AL555
：System Failure
N/A