Delta DVP-ES3 Series Hardware Manual

DVP-ES3/EX3/SV3/SX3 Series Hardware and Operation Manual
14-12
_14
Modify and compile the program and then
download the program again.
2003
The device used in the program
exceeds the device range.
Check the syntax error step in the program. Modify
and compile the program and then download the
program again.
SM0 V
200B
The operand n or the other constant
operands K/H exceed the range.
SM0 V
200C
The operands overlap.
SM0
V
200D
The binary to binary-coded decimal
conversion is incorrect.
SM0 V
200E The string does not end with 00. SM0 V
2012
Incorrect division operation
SM0
V
2013
The value exceeds the range of values
that can be represented by the
floating-point numbers.
SM0 V
2014
The task designated by the TKON or
YKOFF instruction is incorrect or
exceeds the range.
SM0 V
2017
The instruction BREAK is written outside
of the FOR-NEXT loop.
SM0 V
2027
No such position planning table number
or the format is incorrect.
1. Check the program, compile the program again,
and download the program again.
2. Check the settings of the position planning table.
SM0 V
2028
High speed output instruction is being
executed. Only one instruction can be
executed at a time.
Refer to SR28 for the record of the axis number and
rearrange the output control procedures.
-
V
6004 The IP address filter is set incorrectly.
Set the Ethernet parameter for the CPU module in
HWCONFIG again.
SM1108 X
600D
RJ45 port is not connected.
Check the connection.
SM1100
X
6012
There are devices using the same IP
address.
1. Check if there are devices using the same IP
address.
2. Check if there is more than 1 DHCP or BOOTP
server on the network.
SM1101 V
6100 The email connection is busy.
Retry the email connection later. This error does not
cause the PLC to stop running. Solve the problem
by means of the related flag in the program.
SM1113 X
6103
The trigger attachment mode in the
email is set incorrectly.
Set up the trigger attachment mode in HWCONFIG
> CPU Module > Device Setting > Options >
Ethernet Port Advanced > Email > Trigger Setting >
Trigger Attachment Mode.
SM1113 X
6104
The attachment in the email does not
exist.
Check whether the attachment exists in the
memory card.
SM1113 X
6105
The attachment in the email is
oversized.
Check the size of the attachment. If the size is over
2 MB, the file cannot be sent as an attachment.
SM1113 X
6106
There is an SMTP server response
timeout.
Check for the correct address and set up the SMTP
server in HWCONFIG > CPU Module > Device
Setting > Options > Ethernet Port Advanced >
Email again.
SM1113 X
6107
There is an SMTP server response
timeout.
1. Check whether the status of the SMTP server is
normal.
2. Retry sending of the email later. This error does
not cause the PLC to stop running. Solve the
SM1113 X

Delta DVP-ES3 Series Specifications

General

Brand	Delta
Model	DVP-ES3 Series
Category	Controller
Language	English