103
Advanced Setup – Part 1
Setting the Manual EQ Setup
• Allows you to adjust the tonal quality of the various speakers
(except the subwoofer) while listening to a music source.
1
Press the CURSOR
DD
or
HH
button to select the
“Manual EQ Setup” at the “Advanced
Playback” menu, then press the
ENTER button.
• Display the “Manual EQ” screen.
2
Press the CURSOR
FF
or
GG
button to select the
adjustment mode, then press the
ENTER
button.
All CH:
All channels can be adjusted simultaneously.
L/R CH:
The left and right channels of the pair of speakers
can be adjusted simultaneously.
Each CH:
The channels can be adjusted separately.
3
Press the CURSOR
FF
or
GG
button to select the
speaker to be set.
Example: When “L/R CH” is selected.
The display changes as follows.
q Select the “L/R CH”
When the surround back speaker setting is set to
“1spkr” at “Speaker Configuration”, this is set to
“SB”.
e Select the “All CH”
In this case, speaker selection is not performed.
If a value is already set for the FL channel, the data
stored for the FL channel is displayed.
4
Press the CURSOR
DD
or
HH
button to select the
frequency, then press the
CURSOR
FF
or
GG
button to adjust the gain level.
Each frequency can be adjusted the range from –20 dB
to +6 dB in 0.5 dB step.
5
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.
6
Press the CURSOR
DD
or
HH
button to select the
“Exit”, then press the
ENTER button.
• The “Advanced Playback” menu reappears.
To Next Page
Loading...
Need help?
General
