Press the NUMBER/SYSTEM CALL
button to display the screen below.
Press the SOURCE button to display
the screen shown below, to that you
can select an input source.
Basic Operation
42
Operating the remote control unit
• The RC-995 remote control has a backlit LCD screen whose
contents change according to the mode or function selected,
with the appropriate remote commands for that mode or
function.
The function switches as shown below each time one of
the MODE SELECTOR buttons is pressed.
AMP/Z2 : AMP, ZONE2
Z3/Z4 : ZONE3, ZONE4*
(* : This mode can not be used with the AVR-4806.)
2 SURROUND MENU
To select specific surround modes.
2 NUMBER/SYSTEM CALL MENU
Operate the “Number/System call” menu function.
• This function provides the ability to program a series of
individual remote control codes into a macro stored under
one of the number pad’s numeric choices ( page 70 ~
75).
Playback
2 Operate the this unit
The AMP button is the main mode for controlling
the AVR-4806 in the main room (MAIN ZONE).
Press the SURROUND button to
display the screen below to choose a
specific surround mode.
2 SOURCE MENU
To operate the system’s source components.
To Next Page
Loading...
Need help?
General
