119
Advanced Setup – Part 2
• Please set all THX Certifies speakers to small and the
crossover to 80Hz.
•We recommend using with the crossover frequency set to
“FIXED–THX–”, but depending on the speaker, setting it to a
different frequency may improve frequency response near
the crossover frequency.
• The crossover frequency mode is valid only when subwoofer
is set to ON, and when one or more speakers are set to
SMALL, as described in section “Speaker Configuration”
settings ( page 113, 114).
1
Press the CURSOR
FF
or
GG
button to select the
“Advanced” at the “Crossover Frequency”
screen.
2
Press the CURSOR
DD
or
HH
button to select the
speaker to be set.
• If “LFE–THX–” is selected at “Subwoofer Setup”, the
frequencies can only be selected for speakers set to “Small”
at “Speaker Configuration”.
• If “LFE+Main” is set at “Subwoofer Setup”, the frequencies
can be selected regardless of the speaker size setting.
Selecting the Surround Speakers for the
different surround modes
• This menu is displayed when both surround speakers A and
B are used.
• At this screen preset the surround speakers to be used in
each surround modes.
1
Press the CURSOR
DD
or
HH
button to select the
“Surround Sp Setup” at the “Speaker Setup”
menu, then press the
ENTER button.
• Display the “Surround Sp Setup” screen.
• If “LFE+Main” is set at “Subwoofer Setup”, “SW:LFE+Main”
( page 114, 115) is displayed at the top right of the
screen.
Setting the crossover frequency
individually for the different channels
3
Press the CURSOR
FF
or
GG
button to select the
frequency.
To Next Page
Loading...
Need help?
General
